1978 Honda Civic CVCC with a D16A1 engine swap

klyph · Post by **klyph** » January 16th, 2007, 6:37 pm

I guess my other thread got deleted by the 1stgen poltergeist. So here goes with a new thread with all the old pics sans text, plus a few new ones.
Enjoy peoples, more to come.

The last few pics are a bracket I made that connects the stock CVCC motor mount to the Integra Engine/Transmission

klyph · Post by **klyph** » January 17th, 2007, 5:24 pm

I machined the integra hubs into the civic knuckles so the front is 4x100, not sure how I'm gonna attack the rears.

klyph · Post by **klyph** » January 22nd, 2007, 2:58 pm

Finished Rear mount, Almost done with drivers side, but camera died, so I'll post more pics later. Enjoy.

It's closer to being finished than that, but I gotta get the other pics.

klyph · Post by **klyph** » February 2nd, 2007, 3:34 pm

Update

Here are pics that show various clearances (Tie rod, cross member, firewall)

So the motor is finally mounted!

Comments?

klyph · Post by **klyph** » February 5th, 2007, 2:32 pm

I'm planning on repainting it silver.
I hope to have it running this summer to work out the technical kinks, then next winter, tear it down and give it a nice paintjob.

klyph · Post by **klyph** » February 27th, 2007, 4:11 pm

Finished the Transmission Mount, Cleaned the Intake Mani. and Painted the Bay.

klyph · Post by **klyph** » March 1st, 2007, 1:31 am

More Pics, Enjoy

After being on jack stands for so long it really surprised me how low the car is.

klyph · Post by **klyph** » July 10th, 2007, 8:57 pm

Update: I made a new rear mount that is much stiffer and stronger. I am very pleased with how it turned out. Let me know what you think.

zxdriver99 · Post by **zxdriver99** » July 10th, 2007, 10:15 pm

ive been rethinking my motor mounts recently and hockey pucks was the way i was going, but your idea about mounting them sideways makes more sense

klyph · Post by **klyph** » July 11th, 2007, 2:35 am

Yeah, you wanna put them perpendicular to the rotational axis of the engine/drive-line. That way the rubber can dampen some of the higher frequency vibrations. The mount is extremely stiff and virtually solid, so I'm sure this thing is gonna rattle a bit. I was so disheartened when the first rear mount I made ended up being so loose that I could make the engine hit the crossmember by hand, but now that this is done, it seems overbuilt and I hope it will work great.

P.S. feel free to plagiarize anything I do. Imitation is the highest form of flattery

1StGenOfDurham

1StGenOfDurham

1978 Honda Civic CVCC with a D16A1 engine swap

1978 Honda Civic CVCC with a D16A1 engine swap