Restoration

Here is a project or should I say a restoration that has been shared and gotten a lot of attention since January 2009. 559

I have the most part of the door pillar layout done and have started to cut and weld pieces to make it fit.I made

Pillar has been removed, I made a pattern from the drivers side and reversed it using carbon paper.It’s a complicated piece to re-produce. In

Today’s work involved welding an old rocker piece to the door pillar, despite encountering some blow-throughs. The end piece was welded on, a hole

I am preparing to fit the door for alignment before I permanently weld the post in place, I will use a couple of tack

I finally got the door down from the loft to fit on the door pillar I made. I discovered that the rocker panel doesn’t