Project 1979 Honda Civic CVCC almost complete
-
- Short Shifter
- Posts: 104
- Joined: November 13th, 2005, 10:53 pm
- Province/State: Virginia Beach, VA USA
the coilovers are ground control #4525.01 for 88-91 crx the wheels are minilite 15X7 -6 offset I have 205-50 tires but they are too large I have 194 -45 on order they should clear better and lower the car. I have 13X8 +4 offset rota rbs' w/215 -50 for autocross they clear fine and also look great. The front sway bar is stock cvcc I have a larger one but I not sure if i am going to use it. The mirrors are SPA formula style on truechoice motorsports web site. If I can get the car ready I will be at VMP in Petersburg on 1-20- 08. As you can see I am still looking for 78 79 cvcc head lite bezels I need to make camber plates for the front and design a way to adjust the rear camber I have a rear sway bar but havent installed it yet.
Currently working on a '1979 Honda Civic CVCC
- Frankaj
- PsychoCiv
- Posts: 989
- Joined: December 2nd, 2005, 11:50 pm
- Province/State: Washington State
- Kelly
- JDM
- Posts: 467
- Joined: August 25th, 2005, 7:34 pm
- Province/State: Virgina USA
- BABY J
- PanaSport
- Posts: 209
- Joined: August 14th, 2006, 4:06 pm
- Province/State: Atlanta, GA
Can u go into more detail about the mods required for the suspension. To date, this seems like the best suspension solution that I have found on the board -- short of custom shocks and springs.speedycvcc wrote:the coilovers are ground control #4525.01 for 88-91 crx the wheels are minilite 15X7 -6 offset I have 205-50 tires but they are too large I have 194 -45 on order they should clear better and lower the car. I have 13X8 +4 offset rota rbs' w/215 -50 for autocross they clear fine and also look great. The front sway bar is stock cvcc I have a larger one but I not sure if i am going to use it. The mirrors are SPA formula style on truechoice motorsports web site. If I can get the car ready I will be at VMP in Petersburg on 1-20- 08. As you can see I am still looking for 78 79 cvcc head lite bezels I need to make camber plates for the front and design a way to adjust the rear camber I have a rear sway bar but havent installed it yet.
J'son
Message From National Pancake Association: "Screw Waffles!!"
- RBi ZC SB1
- Short Shifter
- Posts: 61
- Joined: April 22nd, 2005, 2:51 am
- Province/State: Metz [France]
- Eduardo I. Nieves Davila
- LSD
- Posts: 1158
- Joined: November 30th, 2007, 6:31 pm
- Province/State: Carolina PuertoRico
-
- Short Shifter
- Posts: 104
- Joined: November 13th, 2005, 10:53 pm
- Province/State: Virginia Beach, VA USA